HID DTC1000/4000/4500 Toolbox User Guide - Manual (Page 16)

DTC1000/4000/4500 Toolbox User Guide - LINUX (L001593 Rev 1.1) 16
Change the value by clicking on the line to activate spin control. After activation you can spin
to the new value or type the new.
If the new value is over the maximum or under the minimum the value is corrected to the
maximum or minimum.
Restore Defaults:
Set all current values to the factory defaults.
Enable Mag Verify:
Use this to enable or disable magnetic verify after write.
To send the new values to the printer click "Apply" or "Ok".
Advanced Settings List:
This list contains details about selected advanced settings:
Image Darkness Use this option to set the overall darkness of the printed
image by increasing or decreasing the amount of heat
(used by the Print head when printing).
Caution: If the value is set too high, the Ribbon may jam
or even break.
Mag Top of Form Use this option to shift the starting point where the Printer
begins to encode the magnetic track data on the card’s
Magnetic Stripe.
Caution: If the negative value is set too high, the Printer
may start encoding before the Magnetic Stripe reaches the
encoding head.
Each increment equals .01”.
Sleep Delay The Sleep Time setting adjusts the number of minutes of
inactivity before the Printer enters a low power sleep state.
Print Top of Form Use this option to adjust the length-wise or horizontal
position of the printed image on the card (so it appears to
be centered).
Caution: If the negative value is set too high, the Print
Ribbon may break.
Print End of Form Use this option to reduce or increase the overall printable
area; this is done in order to optimize edge to edge printing