Shutting down the appliance, Transport storage maintenance and care – Karcher B 40 C Bp R 55 User Manual

Page 13

Advertising
background image

-

4

Press the pedal for lowering the clean-
ing head downwards slightly and then
move it to the left. This unlocks the ped-
al. Release the pedal slowly upwards.
The cleaning head is lowered.

Note
The brush motor comes to a halt when the
machine stops and when there is overload.

Pull the lever out and press it down; the
vacuum bar is lowered.

Note
For cleaning tiled floors, set the straight
vacuum bar in such a way that cleaning is
done at right angles to the joints.
The inclined position and the inclination of
the vacuum bar can be adjusted to achieve
better suction results (see "Setting the Vac-
uum Bar").
If the wastewater reservoir is full, the
floater will close the suction opening and
the suction turbine will run at a higher
speed. If this is the case, shut the vacuum
off and drive to empty the wastewater res-
ervoir.

Close the regulatory button for setting
the water quantity.

Release the safety switch.

Set the program selection switch to suc-
tion or vacuuming.

Lift the cleaning head.

Briefly drive forward and suck of the re-
maining water.

Raise the vacuum bar.

Disconnect the main plug from the
socket.

Warning

Please observe the local provisions regard-
ing the wastewater treatment.

Take the water discharge hose from the
support and lower above a suited col-
lection device.

Crush or bend the dosing equipment.

Open the lid of the dosing equipment.

Drain off the dirt water - regulate the
water quantity by pressing or bending.

Rinse the wastewater reservoir with
clea water or with the rinsing system for
the wastewater reservoir (option).

Loosen the lid for emptying the fresh
water - do not remove it fully. Drain wa-
ter.

To rinse the fresh water reservoir, re-
move the cover completely and remove
the fresh water filter.

ƽ

Danger

Risk of injury! When loading or unloading
the machine, it may only be operated on
gradients of max. incline (see "Technical
Specifications"). Drive slowly.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.

Raise the cleaning head to avoid dam-
age to the brushes.

Remove the brush to avoid damage to
the brushes.

When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

ƽ

Danger

Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.

Drain and dispose of the dirt water and
the residual fresh water.

Caution
Risk of damage. Do not wash down the ap-
pliance with water and do not use aggres-
sive detergents.

Drain off dirt water.

Rinse the wastewater reservoir with
clea water or with the rinsing system for
the wastewater reservoir (option).

Remove the coarse dirt sieve from the
wastewater reservoir and clean it.

Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.

Check the fluff filter, clean if required

Only BR model: Remove bulk waste
container and empty it.

Only BR model: Clean water distributor
channel (see section „Maintenance
work“).

Clean the vacuum lips and the wiping
lips, check for wear and replace if re-
quired.

Check the brushes for wear, replace if
required.

Press the lock of the wastewater reser-
voir in and close the cover of the waste-
water reservoir so that a gap remains
open to facilitate drying.

Clean the seals between dirt water res-
ervoir and cover and check for tight-
ness, replace if required.

Clean the brush tunnel (only BR mod-
el).

Have the prescribed inspection carried
out by the customer service.

Take the dirt water discharge hose from
the support and lower above a suited
collection device.

Open the lid of the dosing equipment.

Open the cover of the wastewater res-
ervoir.

Pull the flexible lock off of the rinsing
system.

Connect the water hose to the rinsing
system.

Lower the cleaning head

Lower the vacuum bar

Shutting Down the Appliance

Drain off dirt water

Drain off clean water

Transport

Storage

Maintenance and care

Maintenance schedule

After each operation

Monthly

Yearly

Maintenance Works

Wastewater reservoir rinsing system
(option)

13

EN

Advertising