AEG LAVAMAT 74610 - Manual (Page 15)

15
Programme progress
• The programme progress display shows the programme step that is
currently being carried out.
–
(Prewash)
– (Main wash)
– (Rinse)
– (Extra Rinse)
– (Spin)
– (End)
• The multi-display shows the estimated time remaining (in hours and
minutes) until the end of the programme.
3
The remaining programme time may increase or briefly remain constant
during the wash programme as the programme adjusts to various con-
ditions while washing (e. g. type of washing, amount of washing, rec-
ognising out-of-balance when spinning, special rinse cycle, etc.).
Interrupting a programme/Adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
button (START/PAUSE) and then re-started by pressing the
button (START/PAUSE) again.
• To stop the washing machine before the programme has ended, turn
the programme knob to (OFF). Important: Washing can be added,
as long as the light (DOOR) is lit in green.
1. Press the button (START/PAUSE). The door can be opened.
2. Close the door and press the button (START/PAUSE) again. The
programme will continue.
End of the wash cycle/Removing the washing
When the programme has finished, (END) will illuminate on the pro-
gramme progress display. The door can be opened as soon as the in-
dicator (DOOR) is lit green.
1. Open the door and remove the washing.
2. Turn the programme knob to
(OFF).
3. When you have finished washing, pull out the detergent drawer a little
to let it to dry out. Keep the door very slightly open so that the washing
machine can air.