Karcher AB 20 - Manual (Page 14)

– 5
For the drying of floors directly underneath
the device.
 Rotate the regulating disc so that the 4
air outlet bores are open.
 Rotate the regulating disc so that the 4
air outlet bores are closed.
 Place the device on the carpet to be dried.
 Open the air outlet on the bottom of the
device.
 Stretch a tension belt over the air outlet
on the device.
 Lift the carpet.
 Slide the air outlet of the device under
the corner of the carpet so that the air
outlet is facing the centre of the carpet.
 Fasten the corner of the carpet with the
tension belt. Ensure that the air intake is
not obstructed.
 Plug in the main plug.
 Turn on the machine. Indicator lamp
glows green.
 Perform the drying process.
 Turn off the appliance. Indicator lamp
goes off.
 Pull out the mains plug.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.

Coil the power cord around the cable
storage and affix with the tension belt.
 Transport the device using the carrying
handle.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Note: These devices can be stacked (6
max.). When stacking, the devices must be
secured with a tension belt.
Regulating disc
Open the air outlet on the bottom of the
appliance
Close the air outlet on the bottom of the
appliance
Drying the carpet from the top
Drying the carpet from below
Turning on the Appliance
Drying
Turn off the appliance
Transport
14 EN