Karcher KM 130-300 BAT - Manual (Page 7)

- 2
1 Ignition key
– Position 0: Switch off engine
– Position 1: Ignition on
– Position 2: Start the engine
1 Work lights on/off (option)
2 Beacon lamp on/off
3 Horn
4 Filter dedusting
5 Blinker switch
6 Blower
7 Open/close container lid
8 Raise/lower waste container
1 Battery capacity
2 Battery control lamp
3 Control lamp operating state
4 Indicator lamp for sidelights
5 Indicator lamp (not connected)
6 Indicator lamp for dipper
7 Indicator lamp (not connected)
8 Indicator lamp - forward driving direc-
tion
9 Indicator lamp - reverse driving direc-
tion
10 Operating hour counter
1 Drive pedal
2 Brake pedal
3 Parking brake
 Check battery charging status; charge
batteries it if required (see Chapter
"Charging the batteries").
1 Transport drive
2 Sweeping with sweep roller
3 Sweeping using roller brush and side
brushes
 Loosen parking brake; press brake
pedal at the same time.
 Activate the parking brake; press brake
pedal at the same time.
 Pull seat adjustment lever outwards.
 Slide seat, release lever and lock in
place.
 Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Note:The machine is equipped with a seat
contact switch If the driver's seat is vacat-
ed, the machine is switched off.

Sit on the driver's seat.
 Bring the direction selector switch into
the middle position.
 Lock parking brake.
 Insert the ignition key into the ignition
lock.
 Turn the ignition key to position "I".
The appliance is now ready for opera-
tion.
 Turn the ignition key to position "II".
The appliance can now be driven.
Note: The display of the battery capac-
ity will show the actual charge status af-
ter about 10 seconds.
 Set programme selection switch to
"Transport drive".
.
 Press brake pedal and keep it de-
pressed.
 Release parking brake.
 Set the travel direction switch to "for-
ward".
 Press accelerator pedal down slowly.
ƽ Danger
Risk of injury! While reversing, ensure that
there is nobody in the way, ask them to
move if somebody is around.
Caution
Risk of damage. Only use the direction
switch when the machine is standing still.

Set the travel direction switch to "back-
wards".
 Press accelerator pedal down slowly.
– The accelerator pedal can be used to
vary the driving speed infinitely.
– Avoid pressing the pedal suddenly as
this may damage the hydraulic system.
 Release the accelerator pedal, the ma-
chine brakes automatically and stops.
Note: The braking effect can be supported
by pressing the brake pedal.
Driving over fixed obstacles which are 70
mm high or less:

Drive forwards slowly and carefully.
Driving over fixed obstacles which are
more than 70 mm high:

Only drive over these obstacles using a
suitable ramp.
 Press brake pedal and keep it de-
pressed.
 Lock parking brake.
 Turn ignition key to "0" and remove it.
Operating and Functional El-
ements
Ignition lock
Function keys
Indicator lamps and display
Pedals
Start up
General notes
Operation
Programme selection
Lock/ release parking brake
Adjusting driver's seat
Starting the machine
Drive the machine
Drive forward
Reverse drive
Driving method
Brakes
Driving over obstacles
Turn off the appliance
7 EN