Quick connect nozzles – Karcher G 2700 DC User Manual

Page 9

Advertising
background image

English 9

STEP 12:

Pull the starter handle. If the engine fails to

start after 3 pulls, squeeze the trigger gun to
release pressure, and repeat step.

STEP 3:

With the engine running, pull trigger to operate

unit.

Liquid detergent is drawn into the unit and

mixed with water.

Apply detergent to work area.

Do not allow detergent to dry on surface.

STEP 4:

Always draw fresh water through the deter-

gent suction tube when the cleaning job is
done, to rinse/fl ush any remaining detergents
from the injection system.

For best results see Cleaning Tips for specifi c
information on how to clean different surfaces.

Detergents can only be applied with the black
detergent nozzle.

STEP

1:

Install the black detergent nozzle for deter-

gent application at low pressure.

STEP

2:

Fill a container with Kärcher detergent.Place

the fi lter end of detergent suction tube into the
container.

OPERATING INSTRUCTIONS

USING THE ACCESSORIES

WORKING WITH DETERGENTS

CAUTION

High pressure in nozzle area. Risk of injury

caused by improperly locked

nozzle.

Make sure you hear the "click" when inserting

the nozzle tip into the quick connection.

■ Pull the nozzle to make sure it is seated

properly before operating your unit. (See
OPERATING INSTRUCTIONS: Step 1)

WARNING

To avoid serious injury never point spray noz-

zle at yourself, other persons or animals.

The color-coded quick connect nozzles provide a
wide array of spray widths from 0° to 65° and are
easily accessible when placed in the convenient
nozzle holder.

0° spray angle = Red nozzle

For particularly stubborn accumulation of grime.
Not recommended for soft materials like sidings,
decks, painted surfaces, cars.

25° spray angle = Green nozzle

For dirt accumulation over a large surface.

65° spray angle = Black nozzle

For operating with detergents or cleaning with
low pressure.

40° spray angle = White nozzle

For moderate dirt accumulation over a large
surface.

Quick connect nozzles

After the engine warms up enough to run smoothly

move choke rod to OFF position.

Advertising