American Audio WM-UHF16 - Manual (Page 6)

© American Audio ® - www.americanaudio.com - WM UHF16™ Instruction Manual Page 6
Transmitter Set Up
1. Unscrew the bottom part of the microphone. The battery connections (12) are located inside of the
microphone.
2. Insert and connect a fresh 9v battery to the battery connections.
3. Screw the bottom of the microphone back into place.
Receiver Set Up
1. Plug the included AC power supply into the DC input connector on the back of the receiver.
2. Plug the other end of the AC power supply into an AC power outlet.
Note: Make sure the volume on the receiver is turned all the way down befor switching on
the power.
WM UHF16™ SYSTEM SET UP
WM UHF16™ TRANSIMITTER CONTROLS AND FUNCTIONS
12 13
11 10
10. Channel Frequency Selector - Use this knob to choose the receiver operating frequency.
The receiver must be set to the same frequency. You can change the channel with a small flat head
screwdriver.
11. Flat head Screwdriver - Mini flat head screwdriver is used to change the channel frequency on
both the transmitter and receiver.
12. 9v Battery Connection - Connect a fresh 9v battery to these connections.
13. ON/OFF/Mute Switch - This is the main power switch for the transmitter. The transmitter also
has a mute selection. A green LED should glow indicating that the transmitter is ON.