Advantech PC-LabCard PCI-1784 User Manual
Page 19
15
Fig. 2-3 The device name listed on the Device Manager
Note:
✎ If your card is properly installed, you should see the device name of your
card listed on the Device Manager tab. If you do see your device name
listed on it but marked with an exclamation sign “!”, it means your
card has not been correctly installed. In this case, remove the card
device from the Device Manager by selecting its device name and press
the Remove button. Then go through the driver installation process
again.
After your card is properly installed on your system, you can now
configure your device using the PCI-1784 Utility program that has itself
already been installed on your system during driver setup. A complete
device installation procedure should include board selection and device
setup. After that, you can operate this card through the operation. The
following sections will guide you through the board selection, device
setup and operation of your device.