Sony VGP-UVC100 - Manual (Page 24)

6 GB
Installing the driver and the software
Install the VGP-UVC100 device driver for using the camera on the
computer. You can install “VAIO Camera Capture Utility” software for
capturing still images and movies.
Notes
• Make sure that your disk drive, such as CD-ROM drive etc., is available for use on your
computer. In this manual, the CD-ROM drives or multiple disk drives are referred to as
“the CD-ROM drive.” For details on how to connect a CD-ROM drive, refer to the
manuals provided with your computer or CD-ROM drive.
• To use “VAIO Camera Capture Utility,” more than 2 GB free space of the hard disc is
necessary.
• Update Windows before installing the driver and software.
• Exit all software before installing the driver and software.
• Log on as Administrator before installing the driver and software.
• If the “Add New Hardware Wizard” dialog box appears, click “Cancel,” then
disconnect the camera from your computer and reinstall it.
1
Turn on the computer, start the Windows operating system
and insert the supplied installation disc into the CD-ROM
drive.
The installation program starts automatically and the “Sony Visual
Communication Camera VGP-UVC100 Application Installer Setup”
screen appears.
2
Make sure that the checkbox to install the software has been
checked, and click “Next.”
z
Hint
The checkbox will not appear if the software is already installed.
3
Follow the on-screen instructions until the setup finishes and
display closes.
z
Hint
Click “Yes” if a restart pop-up message appears after installation.
4
Connect the USB cable of the camera to the USB port on
your computer.
The necessary driver is installed automatically.
Click “Yes” if a restart pop-up message appears after installation. After
restarting Windows, you can begin using the camera.