Alpine CDA-9856 - Manual (Page 32)

30
-EN
01GB06CDA9856.fm
ALPINE CDA-9856 68-04123Z46-A (EN)
Installation
Accessory List
• Head unit .............................................................................1
• Power cable.........................................................................1
• Mounting sleeve ..................................................................1
• Carrying case ......................................................................1
• Bracket key..........................................................................2
• Screw (M5x8).......................................................................4
• Owner’s Manual .............................................................1 set
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
3. Pull the unit out, keeping it unlocked as you do so.
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
1
Remove the Detachable Front Panel (refer to
page 6). Slide mounting sleeve from main unit (see
“Removal” on page 30).
Detachable
Front panel
Less than 35°
Mounting Sleeve
(Included)
Dashboard
this unit
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
1 ) already
attached to the vehicle's chassis.
• For the screw marked “* 2 ”, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDA-9856. Connect all other
leads of the CDA-9856 according to details
described in the CONNECTlONS section.
3
Slide the CDA-9856 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Install the detachable front panel.
Hex Nut (M5)
Screw
Bolt Stud
this unit
Chassis
Ground Lead
Metal
Mounting
Strap
* 2
* 1
This unit
Bracket keys
(Included)
01GB00CDA9856.book Page 30 Thursday, October 20, 2005 4:33 PM