Specifications, Troubleshooting, Specifications troubleshooting – Sony DSX-A30 User Manual

Page 20: General

Advertising
background image

20

Specifications

Tuner section

FM

Tuning range:

87.5 – 108.0 MHz

Antenna (aerial) terminal:

External antenna (aerial) connector

Intermediate frequency:

25 kHz

Usable sensitivity:

8 dBf

Selectivity:

75 dB at 400 kHz

Signal-to-noise ratio:

80 dB (stereo)

Separation:

50 dB at 1 kHz

Frequency response:

20 – 15,000 Hz

MW/LW

Tuning range:

MW: 531 – 1,602 kHz
LW: 153 – 279 kHz

Antenna (aerial) terminal:

External antenna (aerial) connector

Intermediate frequency:

9,124.5 kHz or 9,115.5 kHz/4.5 kHz

Sensitivity:

MW: 26 μV, LW: 45 μV

USB Player section

Interface:

USB (Full-speed)

Maximum current:

500 mA

Power amplifier section

Output:

Speaker outputs

Speaker impedance:

4 – 8 ohms

Maximum power output:

50 W × 4 (at 4 ohms)

General

Outputs:

Audio outputs terminal (rear)
Power antenna (aerial) relay control terminal
Power amplifier control terminal

Inputs:

Remote controller input terminal
Antenna (aerial) input terminal
AUX input jack (stereo mini jack)
USB signal input connector

Power requirements:

12 V DC car battery

(negative ground (earth))

Dimensions:

Approx. 178 Ч 50 Ч 120 mm

(7

1

/

8

Ч 2 Ч 4

7

/

8

in) (w/h/d)

Mounting dimensions:

Approx. 182 Ч 53 Ч 103 mm

(7

1

/

4

Ч 2

1

/

8

Ч 4

1

/

8

in) (w/h/d)

Mass:

Approx. 0.7 kg (1 lb 9 oz)

Supplied accessories:

Remote commander: RM-X211
Parts for installation and connections (1 set)

Your dealer may not handle some of the above
listed accessories. Please ask the dealer for
detailed information.

Design and specifications are subject to change
without notice.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below,
check the connection and operating
procedures.

For details on using the fuse and removing the
unit from the dashboard, refer to the
installation/connections manual supplied with
this unit.

If the problem is not solved, visit the support
site on the back cover.

General

No power is being supplied to the unit.
 Check the connection or fuse.
 If the unit is turned off and the display

disappears, it cannot be operated with the
remote commander.
– Turn on the unit.

Advertising