Atlas LS 16 - Manual (Page 8)

7 English
7528%/( 6+227,1*
Problem Cause Solution
Connected to improper
power source Use proper power supply Cut-off Saw turns too fast or
develops too much torque
Power source out of
adjustment Adjust power source flow
and pressure settings as per
the manufacturer’s
instructions
Power supply defect Disconnect Cut-off Saw and
check power supply
Valve/valve block defect Repair or replace
Cut-off Saw will not turn at
all or turns too slowly
Motor defect Disconnect power source
and try to turn the motor
shaft by hand. Repair or
replace
Power supply defect Repair or replace Cut-off Saw does not
develop enough torque
(insufficient power to cut
material)
Motor defect Repair or replace
WARNING
Maintenance must be done only by suitably qualified and competent persons.