ATEN CS-82A - Manual (Page 8)

Installation
Refer to the diagram on the next page as you perform the
following steps:
1. Plug the monitor, keyboard, and mouse into the Console
port connectors of the Master View CS-82A unit.
2. Use KVM cables (see the Hardware Requirements section),
to connect the keyboard, monitor, and mouse ports from any
available CPU Port, to the keyboard, monitor, and mouse
ports of the computers you are connecting up).
3. If you choose to use external power (optional) plug the
power adapter into an external AC source; plug the power
adapter cable into the unit s power jack.
4. Turn on the power to the connected computers.
Note: The CS-82A’s Power On default is to link to the first
computer you turn on.
- 6 -
1. Before you begin, make sure that power to all the
devices you will be connecting up have been
turned off. You must unplug the power cords of
any computers that have the Keyboard Power On
function. Otherwise, the switch will receive power
from the computer.
2. To prevent damage to your installation due to ground
potential difference, make sure that all devices on
the installation are properly grounded. Consult your
dealer for technical details, if necessary.
2003-11-25