Sony KDL-32V4500 User Manual
Page 29
Using MENU Functions
29
GB
4 Press
F
/
f
to select one of the following TV broadcast systems, then press
RETURN
.
B/G: For western European countries/regions
I: For the United Kingdom
D/K: For eastern European countries/regions
L: For France
5 Press
F
/
f
to select “Channel”, then press
.
6 Press
F
/
f
to select “S” (for cable channels) or “C” (for terrestrial channels),
then press
g
.
7 Tune the channels as follows:
If you do not know the channel number (frequency)
Press
F
/
f
to search for the next available channel. When a channel has been found,
the search will stop. To continue searching, press
F
/
f
.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the broadcast you want or
your
VCR/ DVD recorder
channel number.
8 Press to jump to “Confirm”, then press .
9 Press
f
to select “OK”, then press
.
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected
channel. This name will be displayed briefly on the screen when the channel is
selected.
To input characters, follow steps 1 to 3 of “Edit:” (page 27).
AFT
Allows you to fine-tune the selected programme number manually if you feel
that a slight tuning adjustment will improve the picture quality.
You can adjust the fine tuning over a range of –15 to +15. When “On” is
selected, the fine tuning is performed automatically.
Audio Filter
Improves the sound for individual channels in the case of distortion in mono
broadcasts. Sometimes a non-standard broadcast signal can cause sound
distortion or intermittent sound muting when watching mono programmes.
If you do not experience any sound distortion, we recommend that you leave this
option set to the factory setting “Off”.
~
You cannot receive stereo or dual sound when “Low” or “High” is selected.
LNA
Improves the picture quality for individual channels in the case of very weak
broadcast signals (noisy picture).
If you cannot see any improvement in the picture quality even if you set to “On”,
set this option to “Off” (factory setting).
Skip
Skips unused analogue channels when you press
PROG +/–
to select channels.
(You can still select a skipped channel using the number buttons.)
Decoder
Shows and records the scrambled channel selected when using a decoder
connected directly to scart connector
/
AV1, or to scart connector
/
/
AV2 via a VCR/DVD recorder.
~
Depending on the country/region selected for “Country” (page 7), this option may not be
available.
Confirm
Saves changes made to the “Manual Programme Preset” settings.
Continued
010COV.book Page 29 Thursday, September 25, 2008 4:59 PM