Alpine CDA-9886M - Manual (Page 46)

44
-EN
Installation
• Stick the supplied cover sheet on the surface of the unit.
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Caution
Do not block the unit’s fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Caution
When you install this unit in your boat, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Air ventilation hole
Detachable Front
Panel
Cover sheet
(supplied)
This unit
Double face tape
Less than 35°
1
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit
(see “Removal” on page 45).
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground to a wire
attached directly to the boat’s negative battery
terminal.
• For the screw marked “*
1
”, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDA-9886M. Connect all
other leads of the CDA-9886M according to details
described in the CONNECTlONS section.
3
Slide the CDA-9886M into the instrument panel until
it clicks. This ensures that the unit is properly
locked and will not accidentally come out from the
instrument panel.
Mounting Sleeve
(Included)
Instrument panel
This unit
Pressure Plates*
Hex Nut (M5) Screw
Bolt Stud
This unit Battery
Ground
Lead
Metal
Mounting
Strap
* 1