Sony KLV-26U2520 - Manual (Page 20)

20 GB
KLV-40/32/26U25xx
3-216-582-31(0)
Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 4)
In TV mode, press PROG +/-, or the number buttons,
to select the video channel.
For other connected equipment
Press
/ repeatedly until the correct input
symbol (see below) appears on the screen.
Additional operations
AV1/ AV1, AV2/ AV2:
Audio/video or RGB input signal through the scart
socket
/ 1 or 2. appears only if an RGB
source has been connected.
AV3:
Component input signal through the Y, P B /C B , P R /C R
sockets / 3, and audio input signal through the
L, R sockets / 3.
AV4/ AV4:
Video input signal through the video socket 4, and
audio input signal through the L (MONO), R audio
sockets
4. appears only if the equipment is
connected to the S video socket 4 instead of the
video socket 4, and S video input signal is input
through the S video socket 4.
5:
RGB input signal through the PC connectors 5, and
audio input signal through the socket .
AV6/ AV7:
Digital audio/video signal is input through the HDMI IN
6, 7 socket. Audio input signal is analogue only if the
equipment has been connected using the DVI and audio
out socket.
To Do this
Return to the normal
TV operation Press .
Access the Input
signal index table Press to access the Input signal
index table. (Then, only in TV
mode, press
g
.) To select an input
source, press
F
/
f
, then press .
To Do this
010COV.book Page 20 Wednesday, April 18, 2007 3:53 PM