Installing the hub on your working surface, 2 installing the hub on your working surface – Acer ALH-608ds User Manual
Page 12
Advertising
2.1.5 Plug the power cord into the outlet on the wall and check if the power
LED lights up. If it lights up, then the hub is ready to be connected to the
network, as shown in
Figure 2-5
.
2.2 Installing the hub on your working surface
You have to find a solid working surface to place the hub and make sure the
equipment is not close to any high voltage power source or over-heated
sources. Also keep away from electronic equipment sensitive to electronic
interference. The brief procedures of installing your hub should be:
2.2.1 Put the hub on a stable working surface, as shown in
Figure 2-6
.
2-4
User's Manual
Figure 2-5
Power on the hub and make it ready
608-UM 1/8/99 2:34 PM
≠∂≠
±10
Advertising