American Standard 1340.825 - Manual

M968492
Certified to comply with ANSI A112.18.1M
SPOUT RECESS
Turn off hot and cold water
supplies before beginning.
CAUTION
Assemble RUBBER WASHER (5) and BRASS WASHER (6) and
LOCKNUT (7) onto SPOUT SHANK (4). Align SPOUT ASSEMBLY.
From underside of ledge, tighten LOCKNUT (7) to secure SPOUT
ASSEMBLY to mounting surface.
!
SPOUT ASSEMBLY PREPARE TUBE AND TEE ASSEMBLY
2
3
1
1
2
1
3
5
6
1340.725
1340.825
1340.855 1340.865
Remove COUPLING NUT (1) and FERRULE (2) from each
VALVE (3) and slide onto TUBING (4).
8"
2
7
4
MOUNTING
SURFACE
NOTE; Washer (5) may remain
inside of Actuator Assembly.
SPOUT
ASSEMBLY
MOUNTING
SURFACE
SPREAD LAVATORY
FAUCETS
Installation
Instructions
Thank you for selecting American-Standard...the
benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Install RING WASHER (1) into SPOUT (2) recess. Check
that O-RING (3) on end of SPOUT SHANK (4) is in place. Insert
SPOUT SHANK (4) into center hole on mounting surface.
METERING
4
1340.725
1340.825
1340.855
1340.865
Plumbers' Putty or Caulking Adjustable Wrench 2.5mm Hex Wrench Channel Locks
TOOLS REQUIRED
REMOVE REPLACE
Remove HANDLE (1) by
removing INDEX BUTTON (2)
and SET SCREW (3) with a
2.5mm hex wrench.
Pull off HANDLE (1).
Remove ACTUATOR
ASSEMBLY (4).
Remove WASHER (5).
REMOVE HANDLE AND
ACTUATOR ASSEMBLY
1
4
5
2
3
Tubing Cutter