Sony RDP-XA700iP - Manual (Page 25)

21 GB
The browser screen does not appear.
• Check the proxy setting of the browser.
This unit does not support proxies. Change
the browser setting to one connecting this
unit without a proxy.
WPS configuration method failed.
• You cannot connect to a network using
WPS when the wireless LAN router/
access point is set to WEP (page 26). Set
up the network using D-Sappli or Access
Point Scan (page 11).
The unit cannot connect to the
network. (The unit cannot be found or
recognized by other devices that are on
the home network.)
• Check that the wireless LAN router/access
point is close to the unit.
• Move the unit and the wireless LAN
router/access point closer to each other
and perform the setup again.
• Make sure that the wireless LAN router/
access point is turned on.
• Turn the unit off and then on again, and
reboot the wireless LAN router/access
point.
• Devices that use a 2.4 GHz frequency band
such as microwave, Bluetooth or digital
cordless device, may interrupt the
communication. Move this unit away from
such devices, or turn off the devices.
The unit cannot connect to the network
via a Wi-Fi connection.
• Make sure a network (LAN) cable is not
connected to the unit. The unit
automatically tries to connect to the
network over a wired LAN connection
when a network (LAN) cable is connected
to the unit.
• Confirm that the wireless LAN router/
access point setting is correct. For details
on the wireless LAN router/access point
setting, refer to the operating instructions
of the wireless LAN router/access point.
Resetting the network settings of the
unit (default network setting)
• Press and hold the ALL RESET button on
the rear of the unit with a thin object such
as a small pin (page 7).
Once you press and hold the ALL RESET
button, the settings of the unit are reset to
the factory default settings.
The “AirPlay” icon or unit name does
not appear on iPhone/iPod touch/ iPad
or iTunes.
• Make sure the LINK indicator lights up
green or amber. See “The unit cannot
connect to the network. (The unit cannot
be found or recognized by other devices
that are on the home network.)” (page 21)
if the LINK indicator turns off or lights up
red.
• Check that this unit, your iPhone/iPod
touch/iPad, Mac or PC are connected to
the same network.
• Update the software version of the unit to
the latest version (page 18).
• Check that your iPhone/iPod touch/iPad or
iTunes has the latest software version.
• If the problem persists, reboot your
iPhone/iPod touch/iPad or iTunes.
• Check your set-up of the firewall of the
security software. Refer to the operating
instructions or the help documentation of
your device or software for details.
Audio content automatically changed/
started/stopped.
• When the unit is turned on or in the
network standby mode, it is under the
control of an “AirPlay” device. If you want
to reject requests from the “AirPlay”
device, turn the unit to the standby mode
by pressing and holding ?/1 button until
the colour of the ?/1 indicator changes.
Network
AirPlay