Reversing a tour, Stopping a tour, Calling salvos (rs232 only) – American Dynamics ControlCenter ADCC0200 User Manual
Page 31: Calling salvos, Reversing tours, Salvos, Stopping tours, Reversing, Stopping
23
Keyboard Installation and Operation
Reversing a Tour
When a tour is running, the NEXT (
) and LAST (
) keys can be used to reverse the
direction of a tour.
To reverse the direction of a tour:
1.
Press the LAST (
) key once. Note, to again reverse the tour, press the NEXT
(
) key once.
Stopping a Tour
A running system or scratch-pad tour can be stopped by calling a camera to be displayed
on the selected monitor.
Calling Salvos (RS232 only)
A
salvo is the simultaneous display of multiple camera scenes on a group of numerically
contiguous monitors. The number of salvo entries allowed is dependant on the matrix
switching system being used. Each system salvo has a unique identification number that
defines the set of contiguous monitors.
To call a salvo:
1.
Enter the identification number of the first (lowest numbered) monitor of the
contiguous monitor group on the numeric keypad. The number entered will
appear on the right hand side of the top line of the LCD display.
2.
Press the MONITOR (
) key.
3.
Enter the identification number for the salvo. The number entered will appear on
the right hand side of the LCD display.
4.
Hold down the SHIFT (
) key and press the MONITOR (
) key.
5.
The salvo will be displayed on the contiguous set of monitors.
Note the "C" in the bottom line of the LCD display will change to "V" while the salvo is
running.
1
S01 M013 V0001