AMX Network Device TX-CTB - Manual (Page 8)

Using the TX-CTB
4 TX-CTB Classroom Transmitter and Barcode Reader
Media Mode
Media Mode is active whenever there is a media source, broadcast channel, or media plan
scheduled to a classroom. You can select up to 10 sources.
! Press SOURCE (up) to pause current media, select next source assignment, and
play assigned media source.
! Press SOURCE (down) to pause current media, select previous source assignment,
and play assigned media source.
Office, Security, or Media Center Control
Calls
There are two different kinds of calls that you can send:
! Office: To send a general emergency call signal to the Paging Console (AXP-PC) or to a
Security Panel (AXU-SPL4) press OFFICE then ENTER. To clear the call before you
receive a response press OFFICE then CLEAR.
! Media: To send a general call to the media center's computer press MEDIA then ENTER.
System Media Control
The TX-CTB has a standard set of motion control buttons located on the right side.
Motion
To control the motion of the media, use the following seven buttons:
PLAY
STOP
PAUSE
FFWD (Fast forward)
REV (Rewind)
FWD (Step forward)
REV (Step reverse)