Sony TA-FE520R - Manual (Page 4)

Getting Started
4 EN
Speaker (L) Speaker (R)
TV or video
deck
Hookup Overview
The amplifier allows you to connect and control the
following audio components. Follow the hookup
procedure indicated for each component that you want
to connect.
To learn the location and name of each jack, see ”Rear
Panel Descriptions” on page 11.
Tape deck DAT deck Tuner
CD player
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the mains leads of the various
components until all connections are completed.
• Use the audio connecting cords supplied with each
component for hooking up with the amplifier.
Purchase and use optionally available cords as
required.
• Be sure to make connections firmly to prevent hum
and noise.
• When connecting an audio connecting cord, be sure
to match the R (right) and L (left) jacks of the
amplifier to the R and L jacks on the other
components.
Audio Component Hookups
Overview
Here you learn how to connect your audio components
to the amplifier.
PHONO
y TUNER
TAPE2/MD EON CONTROL IN CD
TAPE1/DAT AUX
IN REC OUT IN
PHONO
IN
TUNER
IN IN RECOUT IN
CD AUX TAPE2/MD TAPE1/DAT
EON CONTROL
AC OUTLET
SPEAKERS
L
R
IMPEDANCE USE 4 - 16 Ω
SWITCHED 100W MAX +
–
+
–
R L SIGNAL GND y
IN
What cords will I need?
Audio connecting cord (not supplied) (2 for each tape deck,
DAT deck, or MD deck; 1 for other components)
Hookups
The arrow ç indicates signal flow.
Note
The jacks on the TA-FE520R are shown in the following
illustrations.
CD player
IN
CD
L
R
Ç
LINE
OUTPUT
L
R
Tuner
IN
TUNER
L
R
Ç
LINE
OUTPUT
L
R
Turntable
Getting Started
MD deck
g
SPEAKERS ON OFF
BASS •
–10 +10
TREBLE TONE •
–10 +10
BALANCE
LOUDNESS Ø ON ø OFF
•
LEFT RIGHT
VOLUME
0 10
INPUT SELECTOR CD TUNER
PHONO
AUX
TAPE2/MD
TAPE1/DAT
PHONES
EON LINK
STANDBY
SOURCE DIRECT TAPE MONITOR
(TA-FE520R only)
Amplifier
Amplifier Tuner
CD player
White (L)
Red (R) Red (R)
White (L)