Altec Lansing inMotion iM510 - Manual (Page 5)

5
No Power
LED is
lit (AC
Operation). The power supply cord isn’t
connected to a wall outlet and/or
the power supply connector is not
plugged into the power supply jack
on the back of the inMotion iM510.
The surge protector (if used) isn’t
powered on.
The wall outlet is not functioning.
The power isn’t turned on.
Insert the barrel connector from the power supply
into the DC connector on the back of the
inMotion iM510. After this connection is made,
insert the power supply into a wall outlet.
If the power supply cord is plugged into a surge
protector, make sure the surge protector is
switched on.
Plug another device into the same wall outlet to
confirm the outlet is working.
Turn on the inMotion iM510 by pushing the
power button located on the top of the unit. A
blue LED will light around the button when the
power is on.
Symptom Possible Problem Solution
– Turn off the iM510 and disconnect the power
supply.
– Use a USB cable (not included) to connect the
iM510 to your computer.
Note: After syncing the Sansa player to your
computer, be sure to disconnect the USB cable
before reconnecting the power supply or turning
the iM510 on.
CHARGING
The inMotion iM510 can double as a charging
station for your Sansa player. To charge your
Sansa player using the inMotion iM510, follow
the steps below:
– Make sure the iM510 is not connected to a
USB cable.
– Connect the iM510 to a wall outlet using the
power supply.
– Connect the Sansa player to the inMotion
iM510 by plugging the docking bay connector
into the Sansa player port.
Connecting to alternate audio source
The inMotion iM510 system includes an auxiliary
input jack that allows you to connect to alternate
audio sources, such as non-dockable MP3 players,
CD players, portable DVD players, and laptops. To
connect the iM510 to an alternate audio source,
follow the steps below.
1. Connect one end of the 3.5 mm stereo cable
into the auxiliary input jack (AUX) located on
the back of the inMotion iM510 system, and the
other end to the headphone or line out jack on
your alternate audio device.
2. Set the volume on the audio source at mid-level.
3. Set the volume on the inMotion iM510 at
minimum level and adjust upward to a
comfortable listening level.
Volume
The “+” and “–“ buttons on the top of the
inMotion iM510 are the master volume controls.
Press and hold the “+” button to increase the
volume and the “–“ button to decrease the volume.
For Additional Bass
The inMotion iM510 is equipped with a
subwoofer jack (“SUB OUT”). This output should
only be used to connect an Altec Lansing optional
subwoofer specifically designed to increase the
bass output of this speaker system. Please check
www.alteclansing.com/bb2001 for availability
information.
Troubleshooting