Sony VPL-EX1 - Manual (Page 46)

GB 46
Troubleshooting
Remote Commander
Others
Warning Messages
Use the list below to check the meaning of the messages displayed on the screen.
Symptom Cause and Remedy
The Remote Commander
does not work. • The Remote Commander batteries are dead.
c Replace with a new battery (see page 15, 16).
Symptom Cause and Remedy
The LAMP/COVER
indicator flashes. • The lamp cover or the air filter cover is detached.
c Attach the cover securely (see page 42 and 43).
• The lens protector does not open due to a problem.
c Consult with qualified Sony personnel. If it is necessary to use
the projector in case of emergency, use it in the emergency mode
(see page 48).
The LAMP/COVER
indicator lights up. • The lamp has reached the end of its life.
c Replace the lamp (see page 41).
• The lamp becomes a high temperature.
c Wait for 90 seconds to cool down the lamp and turn on the
power again (see page 29).
The TEMP/FAN indicator
flashes. • The fan is broken.
c Consult with qualified Sony personnel.
The TEMP/FAN indicator
lights up. • The internal temperature is unusually high.
c Check to see if nothing is blocking the ventilation holes.
Both the LAMP/COVER
and TEMP/FAN indicators
light up. • The electrical system breaks down.
c Consult with qualified Sony personnel.
Message Meaning and Remedy
High temp.!
Lamp off in 1 min. • Internal temperature is too high.
c Turn off the power.
c Check to see if nothing is blocking the ventilation holes.
Frequency is out of range! • This input signal cannot be projected as the frequency is out of the
acceptable range of the projector.
c Input a signal that is within the range of the frequency.
• The resolution setting of the output signal of a computer is too
high.
c Set the setting of output to XGA (VPL-CX6/EX1) or SVGA
(VPL-CS6) (see page 18).
Please check Input-A
Signal Sel. • You have input RGB signal from the computer when “Input-A
Signal Sel.” in the SET SETTING menu is set to “Component.”
c Set “Input-A Signal Sel.” correctly (see page 38).
Please replace the LAMP. • It is time to replace the lamp.
c Replace the lamp.