Sony VCL-FS2K - Manual (Page 9)

9
-EN
EN
6 Adjusting the optic axis
Refer to the instruction manual of your video camera recorder.
(1) Move the telescope mounting plate close to the lens of the video camera
recorder (1 ) and tighten the telescope mounting screw securely (2 ).
(2) Set the video camera recorder in standby mode and set the zooming to the
maximum position of wide-angle side (W).
(3) Position the circle in the viewfinder in the center with the right and left width
control screw (a) and the up and down width control screw (b).
If the circle is skewed to the top or bottom, adjust with the angle control screw
of the video camera recorder plate (c. rear side).
(4) When the circle is in the center of the viewfinder, loosen the telescope
mounting screw (1 ). Move the telescope so that the eyecup of the eyepiece
just touches the video camera recorder (2 ) and fasten the telescope mounting
screw again (3 ).
1
3
Preparing
inside the viewfinder
(c) Angle control screw of video
camera recorder plate (rear)
(a) Right and left width control
screw
(b) Up and down width control
screw
1
2