Sony VGN-FZxx Series Hard Disk Drive (Replacement Instructions) - Manual

VGN-FZxx Series Hard Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994654600 Rev. B 1/2
Step 1. Prepare the Computer.
CAUTION : Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Place the computer upside down on a
protected surface with the front edge
facing you.
Step 2. Remove the Battery Pack.
Locate the two tabs securing the battery
pack. Using your thumbs and fingers
push both tabs in the release direction.
Carefully remove the battery by lifting the
side where the arrow is pointing.
(HDD Removal) Steps 3-7
Step 3. Locate HDD Bay.
Rotate the computer with the Hard
Disk Drive (HDD) bay facing you as
shown in the picture.
These easy instructions are intended to guide you through the replacement process. If you need additional
help, please call 1-866-651-7669 for technical support from 9:00 am to 11:00 pm EST.
9
To avoid electric shock, please make sure product is turned off and AC Adaptor is disconnected
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
9
Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer’s case.*
9
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
9 The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of
the computer under these procedures. The terms of your Sony limited warranty continue to apply.
IMPORTANT!
PLEASE READ BEFORE YOU START
HDD Bay
Lift to remove
Push tabs in the release direction