Sony RHT-S10 - Manual (Page 8)

8 US
Install the unit after allowing for a space of 300
mm (11
7 / 8 inches) or more on the right and left
from the wall.
A 300 mm (11 7 / 8 inches)
B 50 mm (2 inches)
Connecting the FM wire
antenna (aerial)
Connect the FM wire antenna (aerial) to the FM
75
Ω COAXIAL ANTENNA jack.
• Adjust the direction of the FM wire antenna (aerial)
for best FM broadcast sound.
• If you attach the FM wire antenna (aerial) to a wall,
select a wall for best reception.
• Do not use the FM wire antenna (aerial) rolled up.
• Be sure to insert the FM wire antenna (aerial) fully
into the jack.
• If you have poor FM reception, use a 75-ohm coaxial
cable (not supplied) to connect the unit to an outdoor
FM antenna (aerial).
Connecting the power cord
1
Connect the components to this unit.
For details of connecting the components,
see page 9 to page 13.
2
Connect the power cord of this unit to
the wall outlet.
• Install this system near the wall outlet so that the AC
power cord (mains lead) can be unplugged from the
wall socket immediately in the event of trouble.
Installing this unit
Install the unit after connecting all the
components to the unit.
When installing the unit, allow for a space of at
least 50 mm (2 inches) from the wall and 300
mm (11
7 / 8 inches) or more on the right and left
when you install the unit. This is to allow for heat
dissipation, a sufficient surround effect, and to
prevent the TV from falling.
• Do not put a magnetic card (such as a cash card or
commuter pass) close to the speaker. The card may
become unusable because of the magnetism of the
speaker’s magnet.
Installing the unit
POWER / HDMI POWER + VOLUME - + PRESET MULTI CH INPUT SELECTOR - POWER / HDMI POWER + VOLUME - + PRESET MULTI CH INPUT SELECTOR -
Subwoofer
B
A A
FM 75
COAXIAL SAT IN BD/DVD IN TV OUT
HDMI ANTENNA
FM wire antenna (aerial) (supplied)
FM 75 Ω COAXIAL ANTENNA
jack
Notes
Tip
Note
Note
FM 75
COAXIAL
ANTENNA