Sony ERS-7 - Manual (Page 85)

Settin
g
s
85
Changing the date and time
The AIBO
®
Entertainment Robot has a built-in clock.
To change the date and time settings, the AIBO robot must be on the Energy Station.
Caution
• When the AIBO robot is not on the Energy Station, you cannot change the setting. If you attempt to
change this setting when the AIBO robot is not on the Energy Station, the pump and battery indicators
on the LCD display will flash for several seconds to indicate that the AIBO robot is not on the Energy
Station.
• To turn ON the display panel backlight, press the LIGHT/+ button. The backlight stays on for about 60
seconds when the AIBO robot is on the Energy Station, and for about four seconds when the AIBO robot
is not on the Energy Station.
Setting the date and time
The following procedure assumes that the date display format is “Year/Month/Day”.
1
Place the AIBO robot on the Energy Station.
2
Press the MODE/NEXT button repeatedly until the date or time indication
appears.
Each push of the MODE/NEXT button cycles through the display indications for date
t time t time zone t volume.
3
Press the SET/CANCEL button.
The year indication starts to flash.
Caution
Only the last two digits of the year are shown (such as
“03” for 2003).
4
Use the DISPLAY/- or LIGHT/+ buttons to set the year. Then press the
MODE/NEXT button.
The month indication starts to flash.
5
Use the DISPLAY/- or LIGHT/+ buttons to set the month. Then press the
MODE/NEXT button.
The day indication starts to flash.