Sony DCR-SR62 - Manual (Page 10)

10
Power supply
You can use your camcorder in any countries/
regions using the AC Adaptor supplied with your
camcorder within the AC 100 V to 240 V, 50/60 Hz
range.
Use a commercially available AC plug adaptor [a],
if necessary, depending on the design of the wall
outlet [b].
Using the Remote Commander for the
first time
Remove the insulation sheet before using the
Remote Commander.
To change the battery of the Remote
Commander
1 While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
2 Place a new battery with the + side facing up.
3 Insert the battery case back into the Remote
Commander until it clicks.
• When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may not
function properly. In this case, replace the battery
with a Sony CR2025 lithium battery. Use of
another battery may present a risk of fire or
explosion.
On the Remote Commander
(except for DCR-SR42)
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
AC-L200/L200B [a] [b]
Insulation sheet
Tab