Using the bluetooth standby function, Help guide – Sony SRS-X3 User Manual

Page 48

Advertising

Personal Audio System

SRS-X3

Using the BLUETOOTH standby function

When the BLUETOOTH standby function is turned on, the speaker turns on automatically by operating a BLUETOOTH

device, and starts the BLUETOOTH connection.

Before operating the speaker, note the following:

The BLUETOOTH standby function can be set only when the speaker is connected to an AC outlet via the USB AC

adaptor. When the speaker is being powered by the built-in battery only, the BLUETOOTH standby function is not

available.

If pairing information is not stored in the speaker, such is the case when the speaker is shipped from the factory, the

speaker will not enter the BLUETOOTH standby mode.

1. Connect the speaker to the AC outlet.

2. Turn on the speaker.

The

(power) indicator lights up in green.

3. Press and hold the

(power) button over 4 seconds until the

(power) indicator lights up in orange.

The speaker turns off and enters the BLUETOOTH standby mode.

If you connect to the speaker from a BLUETOOTH device, the speaker turns on automatically and starts the

BLUETOOTH connection.

To turn off the BLUETOOTH standby function

Perform step 1 to 2 above again and press and hold the

(power) button over 4 seconds until the

(power)

indicator goes off. The BLUETOOTH standby function is turned off and the speaker will turn off.