Sony DR-BT30Q - Manual (Page 16)

16
US
When you want to connect the unit
to a different BLUETOOTH mobile
phone from the last time, follow the
procedure in “When this unit does
not connect to a BLUETOOTH
mobile phone automatically.”
When this unit does not
connect to a BLUETOOTH
mobile phone automatically
1 Make the BLUETOOTH
connection (HFP or
HSP) from the
BLUETOOTH mobile
phone to this unit.
Refer to the manual supplied
with your BLUETOOTH mobile
phone for operation details.
The list of recognized devices
appears on the display of the
BLUETOOTH mobile phone.
This unit is displayed as
“DR-BT30Q.”
When you use the
BLUETOOTH mobile phone
features both HFP (Hands-free
Profile) and HSP (Headset
Profile)*, set to HFP.
* For details on profiles, see
page 23.
Note
When listening to music by operating this
unit connected to a BLUETOOTH mobile
phone, make the BLUETOOTH
connection by operating the
BLUETOOTH mobile phone. This cannot
be done with the multi function button.
Check the following before
operating the unit.
– The BLUETOOTH function is
active on the mobile phone.
– Pairing of this unit and the
BLUETOOTH mobile phone is
complete.
1 Press and hold the
POWER button for
about 3 seconds while
the unit is turned off.
The indicator (blue) and
indicator (red) flash together
twice, the unit turns on and then
this unit automatically connects
to the last BLUETOOTH mobile
phone that was used.
Note
Do not press and hold the POWER
button for more than 7 seconds,
otherwise pairing mode is entered.
Tip
This unit will stop trying to connect
to the BLUETOOTH mobile phone
after 1 minute. In such a case, press
the multi function button to try to
connect again.
POWER button
VOLUME + button
VOLUME – button
Multi function
button
Calling