Sony HCD-GSX100W - Manual (Page 36)

masterpage:Left
filename[\\Win-
78\got78\GSX100Wkaihan\DTP\4245586122\424558612MHCGSX100WU2\GB10TRB-CEL.fm]
36 GB
model name1[MHC-GSX100W/MHC-GSX75]
[4-245-586-12(2)] U2/CA2
After pressing n N or Z PUSH on the tape
deck, there is a mechanical noise, “EJECT”
appears, and the system enters standby mode
automatically.
• The tape was not loaded correctly.
Transmitter
There is no sound.
• Check the connection of the optional component.
• Check that the optional component is turned on.
• Turn up the volume on the connected optional
component, if the transmitter is connected to the
headphones jack.
• Change the radio frequency using the CHANNEL
selector on the transmitter, then press WIRELESS
again.
• If you connect the transmitter to the analog out
jacks of an audio reproducer, make sure that the
NOISE FILTER switch is set to OFF.
• Make sure that the NOISE FILTER switch is set
to either ON or OFF (If the switch gets stuck
between ON and OFF, the sound will be cut off).
There is severe hum or noise.
• If the transmitter is connected to the headphones
jack, turn down the volume of the connected
optional component. If the connected optional
component has the BASS BOOST or MEGA
BASS function, set these function to OFF.
• If the connected optional component has a LINE
OUT jacks, connect its LINE OUT jacks.
• Change the radio frequency with the CHANNEL
selector on the transmitter then press WIRELESS
again.
• If you connect the transmitter to the analog out
jacks of an audio reproducer, make sure that the
NOISE FILTER switch is set to OFF.
Optional components
There is no sound.
• Refer to General item “The clock setting/radio
presetting/timer is canceled.” (page 34) and check
the condition of the system.
• Connect the component properly (page 32) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press VIDEO (MD) to select “VIDEO” or “MD”
(page 33).
The sound is distorted.
• Set the volume of the connected component
lower.