Sony HCD-GSX100W - Manual (Page 11)

Wi
re
le
ss
masterpage:Right
filename[\\Win-
78\got78\GSX100Wkaihan\DTP\4245586122\424558612MHCGSX100WU2\GB04CON-CEL.fm]
11 GB
model name1[MHC-GSX100W/MHC-GSX75]
[4-245-586-12(2)] U2/CA2
Notes
• When you use the main unit inside the effective areas
of the transmitter, the transmitter can be placed in
any direction from the listener.
• Even within the signal reception area, there are some
spots (dead spot) where the RF signal cannot be
received. This is a characteristic inherent to RF
signals, and does not indicate a malfunction. By
slightly moving the transmitter, the location of the
dead spot can be changed.
Notes on receiving performance
This system component utilizes very high
frequency signals in the 900 MHz band so the
receiving performance may deteriorate due to
the surroundings. The following examples
illustrate conditions that may reduce the
possible receiving range or cause interference
with reception.
– Radio waves generated such as cellphones
and cordless phone systems or metal
instruments are placed on the unit.
– Inside a building with walls containing steel
beams.
– Area with many steel file cabinets, etc.
– Area with many electrical appliances capable
of generating electromagnetic noise.
– Transmitter is placed on a metal instrument.
– Area facing roadways.
– Noise or interfering signals exist in the
surroundings due to radio transceivers in
trucks, etc.
– Noise or interfering signals exist in the
surroundings due to wireless communication
systems installed along roadways.
– Transmitter is placed directly on floor.
Placing it up off the floor, such as on a desk,
is recommended.
1
Start playing the connected
component.
2
Press WIRELESS to switch the
function to WIRELESS.
When the sound is distorted
1 Move CHANNEL 1–3 on the transmitter to
select a radio frequency.
CHANNEL1: 913.5 MHz
CHANNEL2: 914.0 MHz
CHANNEL3: 914.5 MHz
2 Press WIRELESS.
“AUTO TUNING” appears.
If you do not hear clear audio, select another
channel using CHANNEL1-3, then press
WIRELESS again.
To finish using WIRELESS
function
Press any function button to select different
function and quit WIRELESS.
Notes
• You may not hear the beginning of the sound from
the main unit until the transmitter starts sending the
RF signals after detecting an audio signal.
• If the transmitter is connected to the headphones jack
of the source component, set the volume of that
component as high as possible without distorting the
audio signal.
• If you hold the antenna of the transmitter with your
hand, noise may occur. However this is not a
malfunction.
• When the transmitter is not to be used for a long
period of time, disconnect the AC power adaptor
from the wall outlet holding the plug. Do not pull on
the cord.
Listening to audio using
wireless system
(MHC-GSX100W only)
continued