Listening to audio from a connected component, Recording audio from a connected component, Recording on a connected component – Sony HCD-GSX100W User Manual
Page 33: Listening to audio from a connected, Component, Recording audio from a connected, Recording on a connected
O
p
tion
a
l C
o
m
p
on
e
n
ts
masterpage:Right
filename[\\Win-
78\got78\GSX100Wkaihan\DTP\4245586122\424558612MHCGSX100WU2\GB09OPT-CEL.fm]
33
GB
model name1[MHC-GSX100W/MHC-GSX75]
[4-245-586-12(2)] U2/CA2
1
Connect the audio cords.
See “Hooking up optional components” on
page 32.
2
Press VIDEO (MD) to select “VIDEO” or
“MD”.
Start playing the connected component.
Notes
• The function is factory-set to VIDEO.
• You cannot switch the function in Power Saving
Mode.
Tip
If you cannot select “MD” by pressing VIDEO (MD)
repeatedly, turn off the system and then press VIDEO
(MD) while holding down x on the unit. The function
will change from “VIDEO” to “MD”, and “MD” will
appear in the display. To change back to “VIDEO”,
repeat the same procedure.
1
Connect the audio cords.
See “Hooking up optional components” on
page 32.
2
Start recording manually.
See “Recording on a tape” on page 22.
1
Connect an optical cable.
See “Hooking up optional components” on
page 32.
2
Start recording.
Refer to the operating instructions provided
with connected component.
Listening to audio from a
connected component
Recording audio from a
connected component
Recording on a connected
component