Adcom GTP-880 - Manual (Page 36)

| ADCOM GTP-880 Owner’s Manual 36 37 ADCOM GTP-880 Owner’s Manual |
3.1 Setup Overview
At this point you should have made all the necessary
physical connections between the GTP-880 and your
source equipment, amplifi ers and speakers. All that
remains is to properly confi gure the system to refl ect your
specifi c equipment and room characteristics.
To turn the GTP-880 on:
1. Plug the cord into an AC wall outlet or UL approved
power strip or surge protection device.
Make certain that the AC power cord supplied with the
GTP-880 is fi rmly inserted into the socket on the unit’s
rear panel.
2. Press the rear panel power switch to the on position to
set the GTP-880 to standby mode.
The standby indicator on the front panel will light up.
3. Press the front panel standby power button to turn on
the GTP-880 or press the power button on the remote
control.
The front panel display will light up and the standby
indicator will turn red.
3.2 On Screen Display
Setup of the GTP-880 is performed by using the remote
control. Information is shown on the front panel display, or
the on screen display (OSD). All selections are made using
a combination of the following buttons:
To use the GTP-880 menu system:
1. Press the main menu button to display the main menu.
The main menu appears on the OSD:
2. Press or followed by the select button to select a
setup menu. Your selection appears on the OSD:
3. Press or to select an item to adjust. Your selection
appears on the front panel display and the OSD:
4. Press or to select or adjust a setting.
Once you have made your selections, you can use the
and to return to the main menu and/or exit the menu
system. Alternatively, pressing the menu button once will
return you to the main menu. Pressing the menu button
a second time will exit the menu system. Note that the
menus will remain visible on the front panel and OSD until
you exit the menu system.
Important Note: When viewing static images such as on
screen menus or video game images using a CRT-based
projector, plasma display or direct-view CRT monitor or
television, there is a risk of permanently “burning in”
the image. Do not leave these images on for an extended
period of time. This type of damage is not covered by the
ADCOM GTP-880 warranty.
3.3 Input Confi guration
Before calibrating your GTP-880 and adjusting loudspeaker
setup and confi guration, you should fi rst set up the sources
connected to it. You will make your selections using the
input confi guration menu, shown below.