Sony VPCL137FX - Manual (Page 3)

VPCL1 Series Optical Disk Drive
Replacement Instructions
P/N 989200673 Rev. A 3/4
Step 11. Take the new ODD and bezel
provided in the CRU kit and prepare for
assembly. Note! Identify tabs on the bezel and tab
holes located on the ODD.
Step 12. Align the tabs on the bezel with
the tab holes located on the ODD. Firmly
but carefully press the bezel into place.
Step 13. Position the new ODD (Label
side down) and identify the correct
bracket with the correct side it is to be
mounted. Notice the different shapes for
each bracket and the way the available
screw holes should align.
Step 14. Firmly but carefully hold the ODD
and begin the re-installation of the screws
& brackets.
Note! Flat surface of bracket should
sit flush with silver side of ODD.
Step 15. To install the new drive, hold the
optical drive by the edges and align it with
the bay opening.
Step 16. To ensure proper assembly and
connection, with even force push the ODD
back into place. You should feel ODD
connect to connector.
(Optical drive should be sitting flush with
the edge of the computer)
St ep 17. Manually eject the ODD to
secure the new ODD to the computer.