ATEN ACS-1714 - Manual (Page 21)

OSD Security
In order to prevent unauthorized access to the computers, the OSD provides a
password security feature. If a password has been set, the OSD will request that
the user specify it before allowing entry. To set a password:
1. Press [F10] to bring up the SET UP configuration menu.
2. Move the highlight bar to PASSWORD, then press [Enter].
3. Key in the new password, then press [Enter].
The password may be up to 8 characters long, and can consist of any
combination of letters and numbers (A - Z, 0 - 9).
4. Key in the new password again, in order to confirm that it is correct, then
press [Enter].
If the two entries match, the new password is accepted and the screen
displays the following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start again from the beginning.
Note: To modify or delete a previous password, access the Password
function as in Steps 1 and 2, then use the backspace or delete key to
erase the individual letters or numbers.
2001-07-05
ACS-1712 / ACS-1714 User Manual 17