Alloy Computer Products WDS2454AP - Manual (Page 7)

3
HARDWARE INSTALATION
LED Indicator
PWR/Power
This indicator lights green when the Access Point receives power. Otherwise, it will be off.
LAN (Link/ACT)
The LED lights green when the LAN port is connected to a 100Mbps Ethernet station, the indicator
blinks green while transmitting or receiving data .
WLAN (Link)
The indicator blinks green while the wireless AP is broadcasting packets.
Rear Panel
The figure below shows the rear panel of the Access Point
- + Ethernet Reset
Antenna 1 Antenna 2
Dual Antenna
Model
Rear Panel
Ethernet
Ethernet uplink port with 10/100Mbps Fast Ethernet connection, connect this port to a switch/hub.
Reset
The Reset button is used to reset the unit back to factory default. To reset the unit to factory default
you will need to hold down the reset button for 10 seconds, the WLAN LED will now turn off. Once
the WLAN LED comes back on the unit is ready for use.
The reset button can also be used to reset the Access Point if the unit locks. Just click the reset
button once to perform this operation.
DC Power
Connect the Power Adapter DC plug to the AP’s power jack.
Antenna
There are two antennas connections on the rear panel of the access point.
These connections can be used to connect external high Gain Antennas.
Note: do not over-tighten or cross thread the RSMA connection on the rear of the access point. Doing
so could damage the unit, and may void the warranty.