Aga Ranges LEGACY F107411-01 - Manual (Page 13)

13
SERVICING  WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Replaceing the Range
Reverse procedure to reinstall the range and lower the front roller.
Make sure the anti-tip device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
Reconnect the power supply
To refit the draw
To replace the drawer in the cooker, pull the side rails fully out.
Carefully move the drawer back between the rails
and rest it on the side rails.
At each side hold the front of the drawer and pull
the side rail forward so that the clips click into
position holding the drawer to the side rails.
3. To Remove a Side Panel
Turn off the power at the circuit breaker.
Pull the range forward.
Pull off the push fi t control panel end caps at
each end and remove the end fi xing screws
under the end cap.
Remove the retaining screws for each panel
(1 at the front and 2 at the rear). The lower
front retaining screws (one each side) are
situated beneath the lower edge at the front
corners of the side panels
Reassemble in reverse order.