Sony DCR-HC30 - Manual (Page 16)

Getting started 16
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (P series) to
your camcorder.
b Notes
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (P series) (p. 129).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall outlet when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
outlet immediately if any malfunction occurs.
1
Attach the battery pack by sliding it in
the direction of the arrow until it clicks.
2
With the v mark on the DC plug facing
down, connect the AC Adaptor to the
DC IN jack on your camcorder.
3
Connect the power cord to the AC
Adaptor.
4
Connect the power cord to the wall
outlet.
5
Slide the POWER switch up to OFF
(CHG) .
The CHG (charge) lamp lights up and
charging starts.
To the wall outlet
DC IN jack
Battery pack
Power cord
AC Adaptor
DC plug
v mark
CHG
CHG (charge)
lamp