Sony MHC-GX450 - Manual (Page 32)

32 GB
Listening to audio using
wireless system
1
Start playing the connected
component.
2
Press WIRELESS on the unit to switch
the function to WIRELESS.
When the sound is distorted
1
Move CHANNEL 1–3 on the transmitter to
select a radio frequency.
CHANNEL 1: 913.4 MHz
CHANNEL 2: 914.0 MHz
CHANNEL 3: 914.6 MHz
2
Press WIRELESS on the unit.
“AUTO SCAN” appears.
If you do not hear clear audio, press WIRELESS
on the unit several times. If this does not work,
select another channel using CHANNEL 1–3 on
the transmitter, then press WIRELESS on the
unit again.
To finish using WIRELESS
function
Press any function button to select different
function and quit WIRELESS.
Notes
• You may not hear the beginning of the sound from
the main unit until the transmitter starts sending the
RF signals after detecting an audio signal.
• If the transmitter is connected to the headphones jack
of the source component, set the volume of that
component as high as possible without distorting the
audio signal.
• If you hold the antenna of the transmitter with your
hand, noise may occur. However this is not a
malfunction.
• When the transmitter is not to be used for a long
period of time, disconnect the AC power adaptor
from the wall outlet holding the plug. Do not pull on
the cord.