Aiwa NSX-D23 - Manual (Page 9)

9
En
Dimmer
Adjusts the brightness of the display.
1 Press DEMO/ECO twice when the unit is turned
on, and then within 4 seconds press ENTER.
2 Turn MULTI JOG to select one of the three dimmer
modes or "DIM-OFF", and then press ENTER.
"DIM-OFF" is the brightest and "DIMMER 3" is the
dimmest.
If there is no MULTI JOG or button operation within 4
seconds, the setting is canceled.
To cancel the dimmer
Repeat the above and select "DIM-OFF".
Setting the
clock
1 Press CLOCK on the remote control.
When the unit is turned off, you can also press aSET.
2 Press f or g to set the time.
Each press changes the time in 1-minute steps. Holding
it down changes the time in 10-minute steps.
If f or g is not pressed within 4 seconds, the
setting is canceled.
•MULTI JOG is also available in place of f or g.
3 Press aSET or ENTER.
The time display stops flashing and the clock starts from
00 seconds.
To display the time
Press CLOCK on the remote control.
The time will be displayed for 4 seconds, but it cannot be
displayed during recording.
To switch to the 24-hour standard
Display the time and press s within 4 seconds.
With each press, the clock alternates between the 12-hour
standard and the 24-hour standard.
Tip:
In the 12-hour standard, "AM 12:00" indicates midnight
and "PM 12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Re-set the clock.
ECO mode
Reduces power consumption with the following operations, etc.
- The unit blacks out when the unit is turned off. Only the red
indicator lights up. (Only when the clock is set.)
- If dimmer mode is set to on, the unit illumination brightens
(for 10 seconds) only when you operate the unit.
1 Press DEMO/ECO once when the unit is turned
on, and then within 4 seconds press ENTER.
2 Turn MULTI JOG to select "ECO ON" and then
press ENTER.
If there is no MULTI JOG or button operation within 4
seconds, the setting is canceled.
To cancel the ECO mode
Repeat the above and select "ECO OFF".