Sony SDM-S95ERB - Manual (Page 4)

4
(US)
Refer to an enclosed instruction,“Assemble
the stand,” for assembling the stand.
2
Tilt the display up.
When using the height adjustable
stand, raise the display higher.
3
Connect your display to a
computer.
If you use the fixed stand, draw the
video signal cables through the stand
hole first and then connect them to the
display.
Connecting a Macintosh computer
Connect the supplied video signal cable to a
video output connector on the computer. If
necessary, use an adapter (not supplied).
Connect the adapter to the computer before
connecting the video signal cable.
4
Connect the supplied power cord
securely to the display’s AC IN
connector.
5
Connect the other end securely to
a power outlet.
6
Secure the cords
x Fixed Stand
Be sure that the cords and cables have been
drawn into the stand hole as illustrated.
x Height adjustable stand
Draw the cords and cables through the cable
holder as illustrated.
Notes
• Slide up the cable holder of the height
adjustable stand to open as illustrated.
• When bounding the cords and cables, be sure to
loosen them a little. If they get pulled hard they
may come off from the connectors or plugs as
you adjust the screen angle. If you stretch the
cords and cables too hard they may get
damaged.
HD-15 DVI-D
INPUT 1 INPUT 2
3
HD15-HD15
video signal
cable
(analog RGB)
(supplied)
DVI-D video
signal cable
(digital RGB)
(supplied)
4
to
AC IN
5
to power outlet
power cord (supplied)
Digital model only
to the HD15
input connector
(analog RGB) to the DVI-D input
connector
(digital RGB)