Sony VPL-HW20A - Manual (Page 28)

28
This section describes how to operate the projector to view the picture from the equipment
connected to the projector. It also describes how to adjust the quality of the picture to suit your taste.
Projecting the Picture on the Screen
* Set the “Input-A Signal Sel.” setting in the Setup menu according to the signal input. When
you set it to “Auto,” and cannot display the picture properly, select an appropriate signal
according to the input signal. (
1 pages 51, 57)
Tips
• When “Auto Input Search” is set to “On” in the Function
menu, only input terminals with
effective signals are displayed in the input palette.
• When “Status” is set to “Off” in the Setup menu, the input palette does not appear. Press of
the INPUT button to switch between input terminals in sequence.
• When the “Control for HDMI” is set to “On” in the Function menu, the input terminal with
effective signals is automatically displayed, synchronizing with the operation of the equipment
connected to HDMI 1 or HDMI 2 input of the projector. (Only when the connected equipment
supports Control for HDMI compatible.)
Projecting
1
Power on both the projector and
the equipment connected to the
projector.
2
Press INPUT to display the input
palette on the screen.
3
Select the equipment from
which you want to display
images.
Press INPUT repeatedly or press
M/m/
(enter) to select the equipment
from which to project. Example: To view the picture
from the video
equipment connected
to the VIDEO INPUT
connector.
To view the picture from Press INPUT to display
Video equipment connected to the VIDEO INPUT connector Video
Video equipment connected to the S VIDEO INPUT connector S-Video
RGB/component equipment connected to the INPUT A connector Input-A*
Component equipment connected to the Y P
B
/C
B
P
R
/C
R
connector Component
Equipment connected to the HDMI 1 connector HDMI 1
Equipment connected to the HDMI 2 connector HDMI 2