Sony KDL-40WL135 - Manual (Page 46)

46
3 Anchor the TV to the wall.
Use the hardware listed below (not supplied).
• Two M6 × 7-10 mm anchor bolts (screw into
the top-most wall-mount holes located on the
rear of the TV).
• Rope or chain (attach to one M6 anchor bolt).
• Wall-anchor (attach to the wall stud) strong
enough to support the weight of the TV (pass
the rope through the wall-anchor, then attach
to the other M6 anchor bolt).
~
• Measure 2 provides minimal protection against the TV
toppling over. For further protection, follow all three
measures recommended above.
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 kgf·cm}.
Rope or
chain
Anchor bolts
Wall-mount
holes
Wall-
anchor