Sony KDL-40WL135 - Manual (Page 16)

16
Use the TV as a monitor for your PC.
Shown below with the HD15 to HD15 connection. This TV can also be connected to a PC with DVI or
HDMI output. (Refer to the separate Quick Setup Guide.)
~
• Connect the PC IN jack to the PC using the HD15-
HD15 cable with ferrite core (analog RGB, not
supplied) and audio cable (page 12).
• If the PC is connected to the TV and no signal has been
input from the PC for more than 30 seconds, the TV
enters the standby mode automatically (page 39).
PC Input Signal Reference Chart
After connecting the PC to the TV, set the output signal from the PC according to the chart below.
~
• This TV’s PC input does not support Sync on Green or
Composite Sync.
• This TV’s PC VGA input does not support interlaced
signals.
• For the best picture quality, it is recommended to use
the signals (boldfaced) in the above chart with a 60 Hz
vertical frequency from a personal computer. In plug
and play, signals with a 60 Hz vertical frequency will be
detected automatically. (PC reboot may be necessary.)
PC
AUDIO
L
R
RGB
PC IN
AUDIO
1 3
IN
HD15-HD15
cable (analog
RGB)
Audio cable
(stereo mini plugs)
Rear of TV
Connect to an HDMI
compatible PC with
an HDMI cable.
Resolution
Horizontal
frequency (kHz) Vertical
frequency (Hz) Standard
Signals Horizontal
(Pixel)
× Vertical
(Line)
VGA 640 × 480 31.5 60 VGA
640 × 480 37.5 75 VESA
720 × 400 31.5 70 VGA-T
SVGA 800 × 600 37.9 60 VESA Guidelines
800 × 600 46.9 75 VESA
XGA 1024 × 768 48.4 60 VESA Guidelines
1024 × 768 56.5 70 VESA
1024 × 768 60.0 75 VESA
WXGA 1280 × 768 47.4 60 VESA
1280 × 768 47.8 60 VESA
1280 Ч 768 60.3 75
1360 Ч 768 47.7 60 VESA
SXGA 1280 × 1024 64.0 60 VESA
1280 × 1024 80.0 75 VESA
HDTV 1920 Ч 1080 67.5 60