Sony DSC-W30 - Manual (Page 84)

84
The image is too bright.
• You are shooting a spotlighted subject in a dark location such as on a stage. Adjust the
exposure (
t step5 in “Read This First” ).
• When the brightness of the screen is too high, adjust the brightness of the LCD backlight
(DSC-W50/W70 only) (page 23,
t step5 in “Read This First”).
The image colors are not correct.
• Adjust the [Color Mode] to [Normal] (page 32).
Vertical streaks appear when you are shooting a very bright subject.
• The smear phenomenon is occurring. This phenomenon is not a malfunction.
Noise appears in the image when you view the screen in a dark place.
• The camera is attempting to increase the visibility of the screen by temporarily brightening
the image under conditions of low illumination. There is no effect on the recorded image.
The eyes of the subject come out red.
• Set [Red Eye Reduction] in the (Setup) menu to [On] (page 48).
• Shoot the subject at a distance closer than the recommended shooting distance using the flash
(
t step 5 in “Read This First”).
• Light the room and shoot the subject.
Dots appear and remain on the screen.
• This is not a malfunction. These dots are not recorded (page 8, t “Read This First”).
The image seen through the finder does not indicate the actual recordable
range.
• The parallax phenomenon is occurring when the subject is close. To confirm the recordable
range, use the LCD screen.
Cannot shoot images in succession.
• The internal memory or “Memory Stick Duo” is full. Delete unnecessary images ( t step 6 in
“Read This First”).
• The battery level is low. Install charged battery pack.
Refer to “Computers” (page 86) in conjunction with the following items.
Viewing images