Sony RDR-HX715 - Manual (Page 14)

14
Hookups and Settings
Hooking Up the Recorder
Follow steps 1 to 7 to hook up and adjust the
settings of the recorder.
b
Notes
• Plug cords securely to prevent unwanted noise.
• Refer to the instructions supplied with the components
to be connected.
• You cannot connect this recorder to a TV that does not
have a video input jack.
• Be sure to disconnect the power cord of each
component before connecting.
Step 1: Unpacking
Check that you have the following items:
• Audio/video cord (phono plug
× 3 y phono
plug
× 3) (1)
• Power cord (1)
• Antenna cable (1)
• Remote commander (remote) (1)
• Set top box controller (1)
• Size AA (R6) batteries (2)
Step 2: Connecting the
Antenna Cable and Set Top
Box Controller
Select one of the following antenna hookups. Do
not connect the power cord until you reach
“Step 5: Connecting the Power Cord” on page 21.
The cable box/satellite receiver control function
can be used with hookup A or B. It allows the
recorder to control a cable box or satellite receiver
via the supplied set top box controller. The
recorder controls channels on the cable box or
satellite receiver for timer recording. You can also
use the recorder’s remote control to change
channels on the cable box/satellite receiver
whenever the cable box/satellite receiver and
recorder are turned on.
To use the cable box/satellite receiver control
function, you need to connect the set top box
controller and set the code number and output
channel (page 25). After setting up the cable box/
satellite receiver control, check that the recorder
can correctly control the cable box or satellite
receiver (page 26).
NOTE TO CATV SYSTEM INSTALLER (IN USA)
This reminder is provided to call the CATV
system installer’s attention to Article 820- 40 of
the NEC that provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the grounding
system of the building, as close to the point of
cable entry as practical.
b
Notes
• If your antenna is a flat cable (300-ohm twin lead
cable), use an external antenna connector (not
supplied) to connect the antenna to the recorder.
• If you have separate cables for VHF and UHF
antennas, use a UHF/VHF band mixer (not supplied) to
connect the antenna to the recorder.
• If you have made hookup A or B and want to use the
TV Guide On Screen system, the cable box must be
turned on, the set top box controller must be connected,
and “Set Top Box Control” in “Settings” setup must be
set to “On” (page 90) to download the TV Guide On
Screen data.
If you have Hookup
Cable box or satellite receiver with a
video/audio output A (page 15)
Cable box with an antenna output
only B (page 16)
Cable without cable box, or antenna
only (no cable TV) C (page 17)
Using the cable box/satellite
receiver control function