Sony HDR-PJ275 - Manual (Page 26)

GB
26
Camcorder temperature
If you use the camcorder
continuously for a long time, the
camcorder gets very warm. This is not
a malfunction.
Overheat protection
Depending on the camcorder and
battery temperature, you may be
unable to record movies or the power
may turn off automatically to protect
the camcorder. A message will be
displayed on the LCD monitor before
the power turns off or you can no
longer record movies. In this case,
leave the power off and wait until the
camcorder and battery temperature
goes down. If you turn on the power
without letting the camcorder and
battery cool enough, the power may
turn off again or you may be unable
to record movies.
Deactivating wireless LAN
(Wi-Fi, NFC, etc.) temporarily
(HDR-PJ275)
When you board an airplane, you can
deactivate the Wi-Fi function
temporarily. Select

[Setup]
 [
General Settings]

[Airplane Mode]
 [On].
Wireless LAN (HDR-PJ275)
We assume no responsibility
whatsoever for any damage caused
by unauthorized access to, or
unauthorized use of, destinations
loaded on the camcorder, resulting
from loss or theft.
If you run into any problems using
your camcorder:
• Check your camcorder referring to
Help Guide (page 7).
• Disconnect the power source,
attach the power source again after
about 1 minute, and turn the
camcorder on.
• Initialize your camcorder.
All settings, including the clock
setting, are reset.
• Contact your Sony dealer or local
authorized Sony service facility.
Troubleshooting