Bits & Pieces Technology RocketChip - Manual (Page 8)

3 . 2 Rocket.~hip I n s t a l l a t i o n f o r t h e A p p l e I I C .
MAKE SURE TEAT THE COMPUTER POWER IS " O F F ”
STEP #1: Removing the Apple IIc cover.
Turn the computer over so that the bottom side is up and the keyboard
side is down, resting on the work surface. Remove the six (6) screws that are
shown in Figure 3. Note that two screws (#1 & #2) are larger than the others.
Save the screws that you have removed.
F i g u r e 3
-
A p p l e I I c B o t t o m S i d e
Turn the computer over so that the keyboard side is up. Use a small
flatbladed screwdriver to release the plastic latches which hold the top cover
in place. Start in the front of the case and work toward the back of the
case, being careful not to damage the plastic. Do not use excessive force.
There are two case styles for the Apple IIc. For the two piece case, try
to leave the back plate which surrounds the back connectors and the power
switch attached to the cover.
When all of the latches are released, pull up on the top cover to remove
it and set it aside.
7